Peakflow SP Reset to Default

Change interface ip

admin@CP5500:/#ip interfaces ifconfig eth0 10.0.0.1 255.255.255.0 up

Stop sp service

admin@CP5500:/# service sp stop
Stoping Peakflow SP services......done.
admin@CP5500:/#

Change bootstrap leader

admin@CP5500:/# services sp bootstrap leader 10.0.0.1 arbor
Existing Alert and Mitigation database detected.
 
The Alert and Mitigation database contains alert information collected
by this device for the deployment which it is a part of.
If this device was last used in a different deployment, then you should
delete the existing database.
 
Would you like to delete the existing Alert and Mitigation database? [n] y
Configuring CP5500
Leader IP:         10.0.0.1
Zone secret hash:  80849306a81e8f4745711a73f5f4f45c
Existing database: delete
 
Commit (and activate) configuration? [n] y
Deleting existing Alert and Mitigation database
Deleting alert and mitigation data.  This could take a while................done.
Rebuilding alert and mitigation database..................//................done.
Saving ArbOS configuration...
Saving SP configuration...
Boot-strap configuration committed
admin@CP5500:/#

Reset all database

admin@CP5500:/# services sp data database reset
  alert            Reset the alert database
  autoconfig       Reset the auto-configuration database
  baseline         Reset the baseline database
  report           Reset the reports database
  traffic          Reset the traffic database
  <cr>
 
admin@CP5500:/# services sp data database reset
  Reset databases? (This operation cannot be undone) [n] y
Deleting baseline data.  This could take a while...done.
Deleting traffic data.  This could take a while..............done.
Deleting alert and mitigation data.  This could take a while...................done.
Rebuilding alert and mitigation database.....................//................done.
Deleting autoconfig data.  This could take a while....done.
Please reset the alert database on all SP devices from the CLI.
admin@CP5500:/# 

Start sp service

admin@CP5500:/# service sp start
Starting Peakflow SP services......done.
admin@CP5500:/#