差異處

這裏顯示兩個版本的差異處。

--- arbor:sp:reset-to-default [2013/09/10 11:38] – jal
+++ arbor:sp:reset-to-default [2015/03/02 09:45] (目前版本) – jal
@@ 行 1: / 行 1: @@
+====== Peakflow SP Reset to Default ======
+===== Command =====
+  - Change interface ip<code cmd>admin@CP5500:/#ip interfaces ifconfig eth0 10.0.0.1 255.255.255.0 up</code>
+  - Stop sp service<code cmd>admin@CP5500:/# service sp stop
+Stoping Peakflow SP services......done.
+admin@CP5500:/#</code>
+  - Change bootstrap leader<code cmd>admin@CP5500:/# services sp bootstrap leader 10.0.0.1 arbor
+Existing Alert and Mitigation database detected.
+The Alert and Mitigation database contains alert information collected
+by this device for the deployment which it is a part of.
+If this device was last used in a different deployment, then you should
+delete the existing database.
+Would you like to delete the existing Alert and Mitigation database? [n] y
+Configuring CP5500
+Leader IP:         10.0.0.1
+Zone secret hash:  80849306a81e8f4745711a73f5f4f45c
+Existing database: delete
+Commit (and activate) configuration? [n] y
+Deleting existing Alert and Mitigation database
+Deleting alert and mitigation data.  This could take a while................done.
+Rebuilding alert and mitigation database..................//................done.
+Saving ArbOS configuration...
+Saving SP configuration...
+Boot-strap configuration committed
+admin@CP5500:/#
+</code>
+  - Reset all database<code cmd>admin@CP5500:/# services sp data database reset
+  alert            Reset the alert database
+  autoconfig       Reset the auto-configuration database
+  baseline         Reset the baseline database
+  report           Reset the reports database
+  traffic          Reset the traffic database
+  <cr>
+admin@CP5500:/# services sp data database reset
+  Reset databases? (This operation cannot be undone) [n] y
+Deleting baseline data.  This could take a while...done.
+Deleting traffic data.  This could take a while..............done.
+Deleting alert and mitigation data.  This could take a while...................done.
+Rebuilding alert and mitigation database.....................//................done.
+Deleting autoconfig data.  This could take a while....done.
+Please reset the alert database on all SP devices from the CLI.
+admin@CP5500:/#
+</code>
+  - Start sp service<code cmd>admin@CP5500:/# service sp start
+Starting Peakflow SP services......done.
+admin@CP5500:/#</code>